News News
公司新闻

current location:Home > News > 公司新闻

Matters needing attention in metal laser cutting machine

author:管理员 Published time:2016-11-24 10:55:35 Read: 0 second

1 comply with general cutting machine safety operation rules. In strict accordance with the laser start procedure to start the laser, light adjustment, test machine.
2 the operator must be trained, familiar with cutting software, equipment structure, performance, knowledge of the operating system.
3 according to the provisions wear good labor protective equipment, in the vicinity of the laser beam must be worn in accordance with the provisions of the protective glasses.
4 do not know whether a material can be used in laser irradiation or cutting, not to its processing, so as to avoid the potential dangers of smoke and steam.
5 operators are not allowed to leave the post without permission to stay in the pipe, such as the need to stop or cut off the power switch if you really need to leave.
6 fire extinguishers should be placed in readily accessible places; do not process to turn off the laser or light gates; do not place in the vicinity of the laser beam without protection of paper, cloth or other flammable materials.
7 abnormal during the process, should be immediately shut down, in a timely manner to eliminate the failure or reported to the competent personnel.
8 laser, laser head, bed and surrounding area clean, orderly, no oil, workpiece, plate, according to the provisions of waste dumps.
The use of 9 cylinders, should avoid crushing welding wire, so as to avoid leakage accident. The use of gas cylinders, transport should comply with the rules of gas cylinders. The ban of gas cylinders in the sun or near the heat of the sun. When the valve is opened, the operator must stand on the side of the bottle mouth.
10 to comply with the high pressure safety procedures. Maintain 1 days per week or 1000 hours per week or six months of maintenance. Follow the rules and procedures.
11 after the boot should be manual low speed X, Y, Z axis direction of the machine, check to confirm whether there is abnormal situation.
12 of the new work program input, should try operation, and check the operation.
13 work, pay attention to observe the operation of the machine tool, so as to avoid the cutting machine out of the effective range or two sets of collision caused the accident.

hotline

0757-6391 8341

tel:0757-6391 8341 Other ways:
address:Nanhai District of Foshan City, Ping Chau Xia Tung Chung Kexun Industrial Zone, Shilong Road, West Second Road on the 1st Fax: E-mail:dingjun123456@126.com
Copyright © 2015Foshan Xingan Laser Technology Co., Ltd
WeChat services sweep